polarstar
For cylinder conversion systems we assign numbers to the nozzles instead of using the rifle model. T..
$31.00
The measured tip length should be within +/- 0.010" of an exiting nozzle to be compatible. If the ti..
$31.00
Features
Modular design with different output and pressure configurations to be available
Si..
$190.00
These metering screws are used to adjust the speed of the nozzle as it returns forward. There is a p..
$15.00
The measured tip length should be within +/- 0.010" of an exiting nozzle to be compatible. If the ti..
$31.00
This replacement PolarStar wire harness is constructed with 24 AWG wire for superior continuity and ..
$15.00
Features
Extremely lightweight and compact design
Dual solenoid design allows for open and c..
$615.00
The REV3 FCU follows the classic design of our very first FCU and it is
considered to be the fines..
$110.00
The MCU wire harness is intended for use with REV3 FCU's that feature
the built in MCU (Motor Cont..
$12.00
Fusion Engine air nozzles allow you to shift the velocity range of your rifle up or down to bes..
$30.00
This switchboard is designed to replace the original trolley type trigger switch in a traditional TM..
$40.00
The Universal Plugboard is used in all Polarstar MG series kits such as the
M249 and is used acros..
$30.00
These have a Red Nozzle and Red Poppet installed directly from Polarstar!Have you ever dreamed of Po..
$750.00
this series of Fusion Engine air nozzles allows you shift the velocity range of your rifle up or dow..
$30.00
Features
Extremely lightweight and compact design
Dual solenoid design allows for open and c..
$615.00
Complete o-ring set for the JACK MP7. Plug screw included.1x M1.5 x 6.5 (Buna 70) - Front Outside of..
$10.00
PolarStar Airsoft - Complete Seal Set for MRS RegulatorComplete seal set for the MRS regulator.1x M1..
$10.00
The trigger lead is mainly used for soldering into the
existing trigger switch of an AEG gearbox s..
$6.00
“JACK” was designed to answer the demand for an affordable, high performance HPA conversion for AEG'..
$470.00
Replacement gauge for PolarStar MRS as well as GEN1 and GEN2 Micro Regs.0-220psi operating range.25m..
$12.00
These poppet shims are used to fine tune your stock or low flow poppet. (If you are purchasing a pop..
$22.00
Introducing the new Amped Airsoft Custom Low Flow Pre-Shimmed Poppet in fabulous purple. We've revis..
$45.00
FeaturesCompletely Custom USA Machined and Designed NozzleProduced in the USASame or better FPS over..
$40.00
With the PolarStar UGS™ (Universal Gas Stock) you can now get the performance advantage of a HPA sy..
$400.00
The Kythera has been the most eagerly anticipated products from PolarStar in the past decade. This H..
$400.00
The Poppet Valve is the part which controls air flow through the
Fusion Engine™. The valve is avai..
$60.00
Switchboard for use with dual or single solenoid cylinder conversion
kits such as the F2, F1 or JA..
$58.00
Version 2 switchboard for GEN3 Fusion Engine.
Header Identification: J1 = Main Harness, J2 = Poppet..
$40.00
The PolarStar Airsoft Modular Regulator System (MRS) is an ultra compact regulator that stands 3 inc..
$210.00
The JACK™ system was designed to answer the demand for an affordable, high performance HPA (High Pre..
$470.00
Showing 1 to 30 of 55 (2 Pages)