• Burst Avocado Ver. IV Programmable Trigger Board MOSFET for AEG (Small Tamiya)

Features

  • User-friendly in-line programming - User can program the AEG at any moment by just using the trigger
  • Programmable shot count from 3/6/9
  • Programmable shoot mode "Auto Fire Mode"
  • Equipped with battery-low protection
  • Equipped with up-to-date power MOSFET technology
  • Active braking technology employed
  • Beep tones available for programming confirmation and battery low indication
  • Self-adjust battery status to suit various types of batteries

Add "burst function" to virtually any Airsoft AEG in seconds! The Burst Avocado provides you reduced gearbox wear and tear, improved trigger control and tactical advantages! The Burst Avocado is the Ver.2 design of the Burst Wizard we previously offered with "easier adjustment", "mosfet technology" and "real time burst fire"!

The "Burst Avocado" is equipped with low-battery detection. There are 2 pre-installed thresholds at 6.3V and 9.3V allowing a wide range of battery voltage to be used. The device will detect the initial voltage when the battery is connected and determine which threshold to be used. Once the battery goes below the preset threshold, the device will generate a warning tone and stop the gun from firing during trigger pull. This is especially useful for LiPo battery applications due to the inherited trait of LiPo batteries where they should not to be drained completely.

Specifications:

Connector Type: Small Tamiya
Size: 45mm x 17mm x 8mm
Operating Voltage: 7.2~12.0V
Maximum Continuous Current: 65 Amp
Recommended operating battery type: Li-po 2~3 cells. (7.4~12V)
Programmable "Burst" Mode: 3/6/9 shots
Programmable "continuous mode: Auto Fire Mode
Battery Low Detection: 6.6V ~ 9.9V
*If your AEG's ROF is higher than 25, there will be a inaccuracy of +1 shot. For example, 2 trigger pull adjustment for 3 round burst and so on.

ONLY use the following types of batteries with the Burst Avocado:

  • NiMH: 7.2v (6 cells), 8.4v (7 cells), 10.8v (9 cells), 12v (10 cells)
  • LiPo: 7.4v (2 cells), 11.1v (3 cells)

  • DO NOT USE NiMH 9.6v (8 CELLS) WITH THIS MOSFET UNIT

    Warranty: The Burst Avocado carries a limited warranty when in an unmodified original condition.


    Write a review

    Note: HTML is not translated!
        Bad           Good
    Captcha

    Burst Avocado Ver. IV Programmable Trigger Board MOSFET for AEG (Small Tamiya)

    • Product Code: 1573
    • Availability: 1
    • $55.00

    Features

    • User-friendly in-line programming - User can program the AEG at any moment by just using the trigger
    • Programmable shot count from 3/6/9
    • Programmable shoot mode "Auto Fire Mode"
    • Equipped with battery-low protection
    • Equipped with up-to-date power MOSFET technology
    • Active braking technology employed
    • Beep tones available for programming confirmation and battery low indication
    • Self-adjust battery status to suit various types of batteries

    Add "burst function" to virtually any Airsoft AEG in seconds! The Burst Avocado provides you reduced gearbox wear and tear, improved trigger control and tactical advantages! The Burst Avocado is the Ver.2 design of the Burst Wizard we previously offered with "easier adjustment", "mosfet technology" and "real time burst fire"!

    The "Burst Avocado" is equipped with low-battery detection. There are 2 pre-installed thresholds at 6.3V and 9.3V allowing a wide range of battery voltage to be used. The device will detect the initial voltage when the battery is connected and determine which threshold to be used. Once the battery goes below the preset threshold, the device will generate a warning tone and stop the gun from firing during trigger pull. This is especially useful for LiPo battery applications due to the inherited trait of LiPo batteries where they should not to be drained completely.

    Specifications:

    Connector Type: Small Tamiya
    Size: 45mm x 17mm x 8mm
    Operating Voltage: 7.2~12.0V
    Maximum Continuous Current: 65 Amp
    Recommended operating battery type: Li-po 2~3 cells. (7.4~12V)
    Programmable "Burst" Mode: 3/6/9 shots
    Programmable "continuous mode: Auto Fire Mode
    Battery Low Detection: 6.6V ~ 9.9V
    *If your AEG's ROF is higher than 25, there will be a inaccuracy of +1 shot. For example, 2 trigger pull adjustment for 3 round burst and so on.

    ONLY use the following types of batteries with the Burst Avocado:

  • NiMH: 7.2v (6 cells), 8.4v (7 cells), 10.8v (9 cells), 12v (10 cells)
  • LiPo: 7.4v (2 cells), 11.1v (3 cells)

  • DO NOT USE NiMH 9.6v (8 CELLS) WITH THIS MOSFET UNIT

    Warranty: The Burst Avocado carries a limited warranty when in an unmodified original condition.


    Write a review

    Note: HTML is not translated!
        Bad           Good
    Captcha

    Tags: Burst Avocado, Trigger Board, MOSFET, Internals, Upgrades