Feature description
Adjustable trigger sensitivity – The trigger can be
set to 5 sensitivity levels for both first and second trigger stage,
ranging from short pull needed to fire a shot, to a long one. No
modification to the trigger or the gearbox is needed and the trigger
sensitivity change is possible even in the field.
Selectable firing modes – User can choose firing modes
available after short or long pull of the trigger: SEMI ONLY, BINARY,
SEMI-AUTO, SEMI-BURST, BURST-AUTO.
Active brake - active brake stops the motor after each
shot preventing spring compression or in case of replicas with high rate
of fire, overspin (double shot problem).
Precocking - Fast trigger response can be a matter of
victory or defeat, especially in CQB situations. With precocking
enabled, piston will remain in rear position after each shot with the
spring already compressed, ensuring that next shot will be fired
immediately after you pull the trigger. To release the spring after
using precocking, pull the trigger and hold it for 2 seconds, after
which a second shot will be fired, this time with no precocking and
fully braked.
Binary trigger - Allows for easy double shots in
semi-automatic setting. After enabling this mode, if semi-automatic fire
is set, shots will be fired not only when the trigger is pulled, but
also when it is released.
Rate of fire reduction - Reduce the rate of fire in automatic or burst fire to save ammo or make the replica shoot in a more realistic fashion.
Low battery voltage alarm - Dedicated for Li-Po and
Li-Ion batteries. Should the battery voltage fall to a dangerously low
level, user will be notified by short sound signals that are repeated
every minute. This may also be freely switched on and off.
DSG – a sector gear detection mode specially prepared to work with dual sector gears.
Diagnostic system - Constantly monitors the replica and
the mosfet itself. In case of any problems, immediately lets you know
what it might be, making troubleshooting much easier.
Electronic fuse - Will save your replica and battery in
case of a major malfunction. It will automatically disconnect the
battery when a short circuit or blocked motor is detected.
Programming of all the settings is done solely by using a button and
multicolor LED diode mounted in the battery compartment and the trigger.
That allows changing the settings in any moment, in a matter of
seconds, even under enemy fire. All settings are set independently for
each selector position, so you can program the mosfet exactly the way
you want, for example semi on semi and binary trigger on auto.
Perun for AUG works without problems with any battery from, 7 V to 17 V. It can also be used with most extreme setups.